Instructions for Authors

IJGAMN publishes research reports; review articles, commentaries, perspectives, case reports, short-rapid communications and letters. All the submitted articles will be subjected for a peer review process by the experts in Editorial and Reviewers Board. Peer review is a system of scrutinizing the paper for validity, significance, originality and conclusion on the publication of manuscript. Once the review process is completed then the revised manuscript is accepted for publication, if it meets the requirements of the review comments. However, the rejected articles can be resubmitted upon approval from the Editor-in-Chief which will be considered as a new submission.

Guidelines for Submission of Manuscript

These guidelines are intended to support the authors for journal's manuscript preparation.

Manuscript Submission

Submission of a manuscript implies: that the work described has not been published before; that it is not under consideration for publication anywhere else; that its publication has been approved by all co-authors, if any, as well as by the responsible authorities – tacitly or explicitly – at the institute where the work has been carried out. The publisher is not legally responsible for any claims of compensation.

Instructions for Authors

General format of a manuscript:

  • Title
  • Introduction
  • Abstracts
  • Keywords
  • Materials and Methods
  • Results & Discussion
  • Acknowledgements
  • References
  • Tables
  • Figures and Legends
  • Manuscript Preparation

    Authors are instructed to include a cover letter along with the manuscript and also a Copyright Transfer, any grants or funds and the Disclosure of Potential Conflict of Interest Agreement (if any). Authors list, Affiliation, Corresponding author's e-mail and affiliation, telephone and fax numbers should be included in the manuscript.

    Text Formatting

    Manuscripts should be submitted in Word. Authors need to use a normal, plain font (e.g., 10-point Times Roman) for text. Use italics for emphasis. Use the automatic page numbering function to number the pages. Do not use field functions. Use tab stops or other commands for indents, not the space bar. Use the table function to make tables. Use the equation editor or Math Type for equations. Save your file in docx format (Word 2007 or higher) or doc format (older Word versions).


    Please use not more than three levels of displayed headings.


    Please provide an abstract of 150 to 250 words. The abstract should not contain any undefined abbreviations or unspecified references. Abstract is an objective representation of the article and it should not contain the results or other data which are not included in the main text.


    Authors are advised to provide 4 to 6 keywords which can be used for indexing purposes.


    Abbreviations should be defined initially and used consistently thereafter.


    All tables are to be numbered using Arabic numerals. Tables should always be cited in text in consecutive numerical order. For each table, supply a table caption (title) explaining the components of the table. Identify any previously published material by giving the original source in the form of a reference at the end of the table caption. Footnotes to tables should be indicated by superscript lower-case letters (or asterisks for significance values and other statistical data) and included beneath the table body.

    Artwork and Illustrations Guidelines

    For the best quality final product, it is highly recommended that you submit all of your artwork –photographs, line drawings, etc. – in an electronic format. Your art will then be produced to the highest standards with the greatest accuracy in detail. The published work will directly reflect the quality of the artwork provided.

    Electronic Figure Submission

    Supply all figures electronically, indicating the graphic program that was used to create the artwork. For vector graphics, the preferred format is EPS; for halftones, please use TIFF format. MS Office files are also acceptable. Vector graphics containing fonts must have the fonts embedded in the files. Name your figure files with "Fig" and the figure number (e.g., Fig1.eps). Do not use faint lines and/or lettering. Check that all lines and lettering within the figures are legible at final size. All lines should be at least 0.1 mm (0.3 pt) wide. Scanned line drawings and line drawings in bitmap format should have a minimum resolution of 1200 dpi. Vector graphics containing fonts must have the fonts embedded in the files.


    Photographs, drawings, or paintings with fine shading, etc. If any magnification is used in the photographs, indicate this by using scale bars within the figures themselves. Halftones should have a minimum resolution of 300 dpi.

    Combination Art

    Color art is free of charge for online publication. If black and white will be shown in the print version, make sure that the main information is still visible. Many colors are not distinguishable from one another when converted to black and white. A simple way to check this is to make a xerographic copy to see if the necessary distinctions between the different colors are still apparent. If the figures are printed in black and white, do not refer to color in the captions. Color illustrations should be submitted as RGB (8 bits per channel).

    Figure Lettering

    To add lettering, it is best to use Helvetica or Arial (sans serif fonts). Keep lettering consistently sized throughout your final-sized artwork, usually about 2–3 mm (8–12 pt). Variance of type size within an illustration should be minimal, e.g., do not use 8-pt type on an axis and 20-pt type for the axis label. Avoid effects such as shading, outline letters, etc. Do not include titles or captions within your illustrations.

    Figure Numbering

    All figures are to be numbered using Arabic numerals. Figures should always be cited in text in consecutive numerical order. Figure parts should be denoted by lowercase letters (a, b, c, etc.). If an appendix appears in your article and it contains one or more figures, continue the consecutive numbering of the main text. Do not number the appendix figures,"A1, A2, A3, etc." Figures in online appendices (Electronic Supplementary Material) should, however, be numbered separately.

    Figure Captions

    Each figure should have a concise caption describing accurately what the figure depicts. Include the captions in the text file of the manuscript, not in the figure file. Figure captions begin with the term Fig. in bold type, followed by the figure number, also in bold type. Neither a punctuation to be included after the number, nor any punctuation to be placed at the end of the caption. Identify all elements found in the figure in the figure caption; and use boxes, circles, etc., as coordinate points in graphs. Identify previously published material by giving the original source in the form of a reference citation at the end of the figure caption.

    Figure Placement and Size

    While preparing figures, size of the figure has to fit in the column width. Figures should be 39 mm, 84 mm, 129 mm or 174 mm wide and not higher than 234 mm. For books and book-sized journals, the figures should be 80 mm or 122 mm wide and not higher than 198 mm.


    If you include figures that have already been published elsewhere, you must obtain permission from the copyright owner(s) for both the print and online format. Please be aware that some publishers do not grant electronic rights for free and that Springer will not be able to refund any costs that may have incurred to receive these permissions. In such cases, material from other sources should be used.


    In order to give people of all abilities and disabilities access to the content of figures, make sure that all figures have descriptive captions (blind users could then use a text-to-speech software or a text-to-Braille hardware). Patterns are used instead of or in addition to colors for conveying information (colorblind users would then be able to distinguish the visual elements). Any figure lettering has a contrast ratio of at least 4.5:1


    Acknowledgments of people, grants, funds, etc. should be placed in a separate section before the reference list. The names of funding organizations should be written in full.


    Authors are requested to provide a list of all the relevant references at the end of the manuscript and the references are numbered consecutively throughout the text. The reference numbers need to placed in square brackets [].

    Some examples

    1. Negotiation research spans many disciplines [3].
    2. This result was later contradicted by Becker and Seligman [5].
    3. This effect has been widely studied [1-3, 7].

    Reference List

    The list of references should only include works that are cited in the text and that have been published or accepted for publication. Personal communications and unpublished works should only be mentioned in the text. Do not use footnotes or endnotes as a substitute for a reference list. The entire list should be numbered consecutively.

    Journal Article

    Gamelin FX, Baquet G, Berthoin S, Thevenet D, Nourry C, Nottin S, Bosquet L (2009) Effect of high intensity intermittent training on heart rate variability in prepubescent children. Eur J Appl Physiol 105:731-738. doi: 10.1007/s00421-008-0955-8
    Ideally, the names of all authors should be provided, but the usage of "et al" in long author lists will also be accepted:
    Smith J, Jones M Jr, Houghton L et al (1999) Future of health insurance. N Engl J Med 965:325–329

    Article by DOI

    Slifka MK, Whitton JL (2000) Clinical implications of dysregulated cytokine production. J Mol Med. doi:10.1007/s001090000086

    South J, Blass B (2001) the future of modern genomics. Blackwell, London

    South J, Blass B (2001) the future of modern genomics. Blackwell, London

    Book Chapter

    Brown B, Aaron M (2001) the politics of nature. In: Smith J (ed) The rise of modern genomics, 3rd edn. Wiley, New York, pp 230-257

    Online Document

    Cartwright J (2007) Big stars have weather too. IOP Publishing PhysicsWeb. Accessed 26 June 2007


    Trent JW (1975) Experimental acute renal failure. Dissertation, University of California. Always use the standard abbreviation of a journal's name according to the ISSN List of Title Word Abbreviations.


    Footnotes can be used to give additional information, which may include the citation of a reference included in the reference list. They should not solely consist of a reference citation and should never include the bibliographic details of a reference, any figures or tables. Footnotes to the text are numbered consecutively; those to tables should be indicated by superscript lower-case letters (or asterisks for significance values and other statistical data). Footnotes to the title or the authors of the article are not given reference symbols. Always use footnotes instead of endnotes.

    Does Scientific Future Group provide English language support?

    Manuscripts that are accepted for publication will be checked by our copyeditors for spelling and formal style. This may not be sufficient if English is not your native language and substantial editing would be required. In that case, you may want to have your manuscript edited by a native speaker prior to submission. A clear and concise language will help editors and reviewers concentrate on the scientific content of your paper and thus smooth the peer review process. The following editing service provides language editing for scientific articles in all areas. Use of an editing service is neither a requirement nor a guarantee of acceptance for publication. Please contact the editing service directly to make arrangements for editing and payment.

    Copyright Transfer

    Open Access articles do not require transfer of copyright as the copyright remains with the author. In opting for open access, the author(s) agree to publish the article under the Creative Commons Attribution License.


    Offprint's can be ordered by the corresponding author.

    Color Illustrations

    Online publication of color illustrations is free of charge. For color in the print version, authors will be expected to make a contribution towards the extra costs.

    Proof reading

    The purpose of the proof is to check for typesetting or conversion errors and the completeness and accuracy of the text, tables and figures. Substantial changes in content, e.g., new results, corrected values, title and authorship, are not allowed without the approval of the Editor. After online publication, further changes can only be made in the form of an Erratum, which will be hyperlinked to the article.

    Online First

    The article will be published online after receipt of the corrected proofs. This is the official first publication citable with the DOI. After release of the printed version, the paper can also be cited by issue and page numbers.

    Peer review process

    Pre quality check: All submitted manuscripts are received by the Editorial Office. Managing Editor will do the intial analysis of the manuscript. Manuscripts that do not fit the journal's scope or are not in line with journal's ethical policy may be rejected before peer-review. Manuscripts which are not well-written will be returned to author for revision.
    Peer review process: After the Pre quality check manuscripts will be assigned to the Editors or outside experts/ reviewers for peer review process. Journal will follow single blind review process, here author's names will be revealed to the reviewers. Two or more reviewers comments will be considered for each manuscript.
    Revisions and Editorial Decision: According Editor's decision Editorial office will suggest the authors for major or minor revisions. Final decision on the manuscript will be done by the editor.
    For any details regarding the manuscript submission and review process, please contact to

    Publication Charges

    Publication charge for research and review articles: 319USD and for all the other types of articles, it will cost 219USD up to 5 pages and additional pages will cost 50USD.